Monogram Ice Maker Repair in Tampa Bay
A Monogram ice maker that produces little ice, cloudy ice, or none at all has a water, freezing, or drain problem that a technician can pin down. We repair built-in and undercounter ice makers across Tampa Bay.

Built-in ice makers run quietly for months, and then one day the bin is nearly empty. Monogram undercounter ice makers freeze water on an evaporator, harvest it, and drain the excess through a line to the house plumbing. Any step in that chain can stall.
Our technicians test the water supply, the freezing cycle, and the drain in order, and we price the repair in writing before starting.
Common Monogram ice maker problems we fix
No ice at all
The water supply, the inlet valve, or the freezing cycle has stopped, and the control may be waiting for a sensor reading.
Slow or small batches
Low water pressure, a clogged filter, or a dirty condenser stretches the cycle and shrinks each batch.
Cloudy, soft, or odd-tasting ice
Mineral buildup, an old water filter, or a unit that has not been cleaned changes how the ice looks and tastes.
Water leaking out front
A blocked drain line, a loose fitting, or an overfull reservoir sends water onto the floor.
Ice melts or clumps in the bin
A drain that does not clear or a door that does not seal lets meltwater refreeze into one block.
Loud grinding or buzzing
The water pump, a fan, or a worn motor mount is making noise as it works harder than it should.
Why is my Monogram ice maker not making ice?
The first suspects are the simple ones: a closed supply valve, a kinked line, or a water filter clogged with sediment. If water reaches the unit but ice never forms, the inlet valve, the evaporator, or the refrigeration system itself may be the cause. A control board waiting for a temperature that never arrives can also keep the unit idle.
Florida water is often hard, and mineral scale builds up on the evaporator and in the water lines. Scale slows ice production and gives the ice a cloudy look. Descaling is a maintenance step, but severe buildup may need parts replaced.
What can I check myself?
Start with safety. Switch the unit off at its control before cleaning, and do not open back or lower panels. Then check only what is reachable from the front.
- Confirm the unit is switched on and the door or drawer is fully closed.
- Look at the supply line and shutoff valve for kinks or leaks.
- Replace the water filter if it is past its change date.
- Check the front grille for dust and make sure air can reach the unit.
When does a drain or leak problem need attention right away?
Water on the floor should never be ignored, especially in a cabinet with wood or stone nearby. Turn off the water supply, dry the area, and call us. A technician checks the drain line, the pump, and the fittings, and finds where the water is coming from before replacing parts. A built-in ice maker in a humid outdoor kitchen also benefits from regular cleaning, since moisture and warm air encourage slime and mold in the bin.
What will the technician explain before starting?
You hear what failed and why, and whether a cleaning, a filter, or a part replacement fixes it. A unit that mostly needs descaling is treated as maintenance and priced that way. If a pump, valve, or sealed-system part needs replacing, the price is written down before work begins, and our labor carries a 30-day warranty.
Ice that will be eaten or served deserves a clean machine, so we also point out cleaning needs we notice during the visit.
Monogram ice maker models we service
Monogram model numbers from current builds back to discontinued ones. The data label tells you yours.
Ice Maker questions
How often should an ice maker be cleaned?
Follow the care instructions for your model. In Florida's humid climate, a regular cleaning and a timely filter change keep the ice tasting clean and slow scale buildup.
Can you repair an ice maker built into my cabinetry?
Yes. We service undercounter and built-in units in place and tell you in advance if the unit has to be pulled forward.
Why is my ice cloudy or tasting strange?
Minerals in the water, an old filter, or residue in the bin can all change the ice. A cleaning and a new filter sometimes fix it; if not, the technician checks the water path.
Should I shut off the water if the unit is leaking?
Yes. Close the supply valve, turn the unit off, and dry the floor. Then call us so the technician can find the leak.


