(813)750-0388 Book a Repair
Troubleshooting · 4 min read

Monogram Ice Maker Stopped After a Power Outage or Water Shut-Off

Monogram Ice Maker Stopped After a Power Outage or Water Shut-Off

A Monogram ice maker that stops after a power outage or a water shut-off usually needs two things: steady power and a restored water supply. Check that the ice maker is switched on, confirm the water valve is open, and allow the freezer to return to temperature. If ice still does not appear, call.

Why does the ice maker stop after an outage?

An ice maker runs on a timed sequence: it fills a mold with water, freezes it, then releases the ice. A power loss in the middle of that sequence leaves the control without a record of where it stopped, and some units need a restart before they begin again.

The freezer also warms during an outage. The ice maker will not make ice until the freezer is cold enough, so after power returns it can take many hours for the unit to start producing again. Patience is part of the fix, and it matters in Florida, where summer outages are common and a warm kitchen slows recovery.

Check that the ice maker is still switched on at its control or arm, since some units turn off after a power event and wait for you to restart them. Your use and care guide shows how.

How do you reset it safely?

Work through the safety steps before any reset.

  1. Make sure there is no water on the floor around the unit. If there is, close the water supply and switch the breaker off.
  2. Close the doors and give the freezer several hours to cool back to its set temperature.
  3. Switch the ice maker off at its control, wait a few minutes, then switch it on again as your guide describes.
  4. If the control stays unresponsive, switch the breaker off for a few minutes and back on.
  5. Throw away the first few batches of ice after a long outage or water shut-off, and let the bin refill.

Do not chip ice out of a jammed ice maker with a sharp tool, and do not pour hot water into the unit. Both can damage the mold, the water lines and the electrical parts.

What if the water supply was shut off?

A water shut-off can come from your own valve, a plumbing repair, a hurricane evacuation or a utility interruption. After water returns, air in the line can keep the ice maker from filling properly, and the first cycles may produce small or hollow cubes.

Confirm the shutoff valve that feeds the refrigerator is fully open, with the handle in line with the pipe. If it is not within easy reach, do not move the appliance. Homes on private wells should also confirm the well pump has power, because the ice maker cannot fill without household pressure.

After a boil-water notice, follow your local utility guidance. Do not use ice made during the notice, and ask your use and care guide about flushing the line and replacing the water filter.

Is the freezer temperature the real issue?

Ice makers need a freezer cold enough to freeze the fill water. If the freezer stays warm, ice never forms, or forms slowly, or clumps together in the bin. Use a freezer thermometer and compare the reading with the temperature your guide recommends for the compartment.

Food in the freezer is another concern after a long outage. Use a thermometer and the USDA guidance on power outages, not appearance. If frozen food has thawed and warmed, do not refreeze it based on how it looks.

What you notice Likely cause What you can check Next step
No ice, ice maker silent Switched off after the outage Turn it back on per the guide Wait many hours
Small or hollow cubes Air or low pressure after shut-off Confirm the valve is open Call if it continues
No ice, freezer warm Cooling problem or still recovering Measure with a thermometer Call if it stays warm
Cloudy or off-tasting ice Filter or water change Replace filter, discard old ice Call if no change
Water on the floor Leak at fill or line Close the supply, breaker off Call right away

When should you call a technician?

Call if the freezer is cold, the ice maker is on, the water valve is open and no ice has appeared after a full day. At that point the water inlet valve, the ice maker module, the sensor or the control may have failed, and each requires a technician.

Call right away for water on the floor, a freezer that stays warm, or an ice maker that makes noise but does not release ice. We check the inlet valve, the fill tube, the module, the freezer airflow and the cooling system, and we confirm the ice maker cycles before we leave.

If you are unsure how service affects your warranty, check your warranty terms. Independent service does not by itself void a warranty.

Frequently asked questions

How long until ice returns after an outage?

It depends on how warm the freezer got, so there is no fixed answer. Give the unit many hours with the doors closed and judge by the freezer thermometer rather than the clock.

Should I throw out ice made right after power returns?

Discarding the first batches is a sensible habit, especially after a long outage or a boil-water notice. The bin and the lines may have held stale water.

Why does the ice maker make noise but no ice?

The ice maker may be trying to fill without water, or the mold may be jammed. Check that the valve is open and the freezer is cold, then call if the noise continues.

Can I use the dispenser while the ice maker is stopped?

Often yes for water, as long as the supply is on. Ice depends on the ice maker, so you may have to wait. If neither works, the supply valve or a lock is the first thing to check.

Sources

Call Book a Repair
Call (813)750-0388 Book a Repair