Monogram ZBD8900PII repair
legacy panel-ready built-in dishwasher. Service for this model across Tampa Bay.

- Model
- ZBD8900PII
- Type
- legacy panel-ready built-in dishwasher
- Years
- Legacy model
- Brand
- Monogram
About the ZBD8900PII
The ZBD8900PII is a legacy Monogram built-in dishwasher that the brand lists for 2009-2011. It is an older model, so we confirm what parts are available early and tell you if a repair looks impractical.
With a ZBD8900PII, standing water makes us look at the drain hose first, then the pump. Cloudy glasses lead us to the filter, and a slow fill leads to the inlet valve. We also inspect the door seal, especially at the corners, where leaks often start. Each step is explained as we go, and you approve a written price before any part is ordered. After the repair we run a full cycle to confirm it fills, washes and drains.
What we check on a ZBD8900PII visit
- Standing water and the drain hose
- Cloudy glasses and the filter
- Inlet valve fill and door seal at the corners
Key features
- Built-in dishwasher
- Listed by Monogram from 2009 to 2011
- Earlier Monogram model
The model number is on the data label: inside the door frame, on the drawer edge or behind the kick plate. We are an independent repair company, not affiliated with Haier US Appliance Solutions, Inc..
Monogram dishwasher codes
Codes listed for Monogram dishwashers. Which ones a unit can show depends on its control board, so we confirm by the full model number.
Other Monogram dishwasher models
DishwasherZBD0700KII / ZBD0700NIIbuilt-in dishwasher, two listed versions
DishwasherZBD071024-inch fully integrated dishwasher
DishwasherZBD1800GSS18-inch built-in dishwasher
DishwasherZBD1850NII18-inch compact built-in dishwasher
DishwasherZBD4200DBBblack American-design built-in dishwasher
DishwasherZBD450024-inch stainless American-design dishwasher
DishwasherZBD4700XBBdishwasher with 9-hour delay start
DishwasherZBD5600DBBblack European-design built-in dishwasherZBD8900PII questions
What do cloudy glasses tell you?
They can point to the filter, the spray or the water supply. We check the filter first, then the arms and the inlet valve.
Why check the door corners?
Corners are where a seal can pull away from the frame, so we look closely along the whole gasket and the area beneath it.