Monogram ZVW8301SW repair
30-inch low-profile wall hood, Statement and Minimalist. Service for this model across Tampa Bay.

- Model
- ZVW8301SW
- Type
- 30-inch low-profile wall hood
- Series
- Statement and Minimalist
- Years
- 2023-2026
- Brand
- Monogram
About the ZVW8301SW
Only 5.875 inches tall, the ZVW8301SW is a slim 30-inch wall hood, listed for 2023 through 2026 in Monogram’s Statement and Minimalist collections. It uses electronic controls and chimney styling, 29.875 inches wide and 18.875 deep.
A low body leaves less room for blower and wiring. We run the fan at each speed and test the controls and lamps. Filters come out for a grease inspection. The duct joint at the back or top follows, because a poor connection wastes airflow. After any repair we retest everything, since parts sit close together inside a slim hood.
What we check on a ZVW8301SW visit
- Response of the electronic controls
- Blower speeds and any buzz
- Filters and duct joint
Key features
- Slim 30-inch wall vent hood
- Electronic controls
- Chimney styling
- Variant ZVW8301SWSS
The model number is on the data label: inside the door frame, on the drawer edge or behind the kick plate. We are an independent repair company, not affiliated with Haier US Appliance Solutions, Inc..
Monogram hood & ventilation codes
Codes listed for Monogram hood & ventilations. Which ones a unit can show depends on its control board, so we confirm by the full model number.
Other Monogram hood & ventilation models
Hood & VentilationZV1050SFSS42-inch high-performance island hood
ProfessionalZV36RSF36-inch stainless professional hood
ProfessionalZV36SSJ36-inch low-profile professional hood
ProfessionalZV370YSS30-inch straight-sided halogen hood
ProfessionalZV371Y30-inch hood with infrared warming lamp
ProfessionalZV48SSJ48-inch stainless professional hood
ProfessionalZV670WSS36-inch taper-sided halogen hood
ProfessionalZV671W36-inch taper-sided warming hoodZVW8301SW questions
Controls respond slowly. Is the hood failing?
The board, connector or panel could be responsible. We test each so you avoid paying for a new board if the cause is a loose connector.
Which finish does this hood have?
The listed variant is ZVW8301SWSS, and the label confirms it, as finish pieces may differ between variants even when hoods look the same.